Online Store:
Tel: +376 355435 & +34 900112200
In stock
can be shipped within 1 days
SX-513: Expansion relay module.
• Controls 4 relays and 3 inputs.
• Relays 1 to 3 are contact Normally Open (NO) and relay contact 4 is switched.
• Each relay can switch a load of 0.5 A (resistive load).
• The operation of each relay is monitored by a LEO red flag.
• The inputs are connected internally to negative, so to activate these should be
connected to positive. The operating voltage is 24 V DC.
• The activation of each input is monitored by a LEO green indicator.
• The No. 3 entry always performs the function of input-STOP (formerly
No. 16 chart entry SX-503).
• It can not work independently and should always be connected to an SX-514 module.
• It is used in linear weighers 1 and 2 heads multihead weighers and stepper motor
step, but not pneumatic.
• The relay functions are predetermined and depend on whether there is a letter SX-512.
Function
(SX-512 with connected)
LINEAR 1 and 2: BOLS
Relay Available 1
Relay Available 2
Lift relay 1
Lift relay 2
Function
(Without SX-512)
MULTI HEADS
Pneumatic vibrator
Lift Control
Automatic weigher
Alarm relay
• Only replace the SX-503 module 1 and linear weighers and multihead 2 heads of
Step by Step. Therefore, the SX-503 module is not obsoleted, and will continue to be used
existing parts.
• To replace an existing SX-503 module in one of the cases mentioned must be installed
one SX-513 module and SX-514. Furthermore, in the case of step multihead necessary
TFT screen that incorporates the SX-533 module inputs / outputs fast, because as
seen in the above table